Rear Mount Bulletproof Kevlar Infused for 2018+ Honda Accord 1.5T & 2.0T

I changed a blown rear mount 30k miles ago with OEM, it went out, I decided to order a stiffer mount since I could feel the OEM one had too much give even when new. This new mount made the car vibrate quite a lot the first week but now it feels softer, but the shift speed and the pick up of the engine is on another level. I would highly recommend and appreciate the fact that products like this are available for my car ( 2.0 T EX-L 2018 accord).

I got the 70A version, and it is solid for what I wanted. I used to have solid Hasport mounts on my EK H22 civic swap, and this lower mount along with the upper torque mount makes it feel like that. The car actually feels sporty now, and feels like you're actually feeling the car and the road a lot better. There's A LOT more internal cabin noise as well. It sounds like the car has an exhaust in the lower RPMs(1-2.5RPM), but tapers off when normal road noise is higher, and the RPMs are in 3-4RPM range. I really like it, but if you're looking for a smooth, quiet ride, maybe stick to stock mounts?

I had previously ordered the upper Hasport 62a mount and that alone made a huge difference in the positive feel of the clutch and reduced so much engine movement. The lower mount has even made this engine and clutch feel so much better. I can't tell you how much of an improvement that his has made. Yes it does increase engine vibrations, it does. But only noticed at idle and when the vehicle is not in motion. If you are adding this it's because you want very little engine movement and you are looking for the ability to increase clutch feel and operation. These two mounts have transformed my ride for the better.
One installation recommendation is to use a 1" hole saw bit to allow the rear bolt hole access without having to remove the plastic shelf underneath it. The hole saw makes quick work of the plastic and makes installation a breeze. The rear bolt hole is torqued to 61ft lbs and the two front bolts are 55ft lbs.

I bought both the upper and lower 62A mounts for my 2.0t accord. Upon the first startup, the vibrations were brutal, it was way more than I was expecting. The whole car was shaking and I could hear plastic rattling in the dash at certain rpms. However, the vibrations seem to be getting slowly better over time. I only have a couple of miles on the mounts and I can feel they loosened up a little already. I hope they continue to loosen up more to the point where they are barely noticeable. These mounts also completely got rid of my wheel hop. When I do a full-throttle pull now the tires simply break loose and spin instead of hopping as they did with the stock mounts. The engine note in the car is also substantially louder, probably twice as loud. These mounts are definitely more aggressive than I imagined, but I expect that they will continue to break in and soften up over time. Install for the rear mount is fairly easy. You can either remove the skid plate under the car to access one of the bolts for the mount or cut off a small piece of the plastic plate instead. Once the old one is removed the new one slides in.